Instructions To Order Spare Parts; Instructions To Request Warranties; Recommendations Of Use Of Concrete Vibrator - ENAR VGR6 Manual De Instrucciones

9

INSTRUCTIONS TO ORDER SPARE PARTS

9.1 INSTRUCTIONS TO ORDER SPARE PARTS
1. All spare parts requested must include PART CODE NUMBER AS STATED IN THE PART LIST.
We recommend to include ITEM´S MANUFACTURE NUMBER.
2. The identification plate with manufacture and model number is located in the rear part of the
motor`s plastic frame. The transmission and pokers have the manufacture number engraved outside.
3. Let us to know the correct shipping instructions, including the wished route and the address and
consignee`s complete name.
4. Don't give back any spare part to the manufacturer without written permission. In case of returned
spare parts shipping fees will always be paid by the customer.

9.2 INSTRUCTIONS TO REQUEST WARRANTIES

1. The warranty is valid for 1 year after the purchasing date of the machine. The warranty will cover
parts with manufacturing defects.
In any case the warranty will cover a malfunction due to improper usage of the equipment.
2. In all warranty requests THE MACHINE MUST BE SENT TO ENARCO, S.A. or to an
AUTHORIZED DEALER, always including the complete address and name of the consignee.
3. The Technical Assistance Service will immediately notify the customer if it accepts the warranty
claim and, if requested, it will send a technical report.
4. The warranty will be rejected if any equipment has been previously handled by personnel outside
of ENARCO, S.A. or not authorized by the manufacturer.
NB: ENARCO, S.A., reserves the right to modify any part of this manual without prior notice.

10 RECOMMENDATIONS OF USE OF CONCRETE VIBRATOR

1. Choose the type of vibrator adequate to the dimensions of the structure to vibrate, the distance
among the reinforcement and the slump cone. It is recommendable to have an additional concrete
vibrator.
2. Before starting, check that the concrete vibrator is in good condition and it works correctly. Use
the means of safety and protection.
3. Pour the concrete in the structure avoiding high heights. Try to pour levelled the concrete. The
thickness of every layer should be less than 50 cm, it is recommendable between 30 and 50 cm.
4. Introduce the vibrator vertically in the concrete mass without moving it horizontally. Do not use the
vibrator to push the concrete horizontally. The concrete vibrator should be introduced into the mass
at regular intervals. The interval should be from 8 to 10 times the diameter of the poker. See the
concrete in the process of vibrating to determine the field of action of the vibrator. This field should
be overlapped to avoid areas without vibrating. To obtain an optimum compacting of the concrete,
plunge it 10 cm into the precedent layer to assure a good adherence. The time in vibrating the
different layers should not be big to avoid cold joints. Do not push or force the vibrator into the mass,
it could be stuck in the reinforcements.
5. The time of vibration in each point depends on the type of the concrete, the size of the vibrator
and other factors. This time can be from 5 to 15 seconds after the immersion in each point. The time
is shorter for a fluid mass, a vibration in excess can produce segregation. It is considered the
concrete to be well vibrated when the surface around the poker is shiny and compact and there is no
more air bubbles, as well a change in the noise of the vibrator is produced. So much defects in
structures are produced due to perform the vibration in an immethodically way and in a hurry.
PETROL ENGINE-ELECTRIC MOTOR-FLEXIBLE SHAFT AND POKERS
VGR6, VGH5, VGE5, VYD, VHD, VLD - VPA, VPAME - TNR - ANR
en
13