Usage Conditions; Operation And Maintenance; Shaft Connection To The Power Unit - ENAR VGR6 Manual De Instrucciones

Proper protective equipment SHOULD BE USED because the acoustic power level of this machine
can be over 80 dB.
WHEN FINISHING the work or when taking a break, the operator SHOULD UNPLUG, disconnect it
from the electrical system, and have it placed in such a way that it should not fall or tip
4

USAGE CONDITIONS

First read the instructions about engine, where the transmissions are connected.
For your own safety, as protection for others, and to avoid damage to the equipment, read carefully
the usage recommendations and the safety instructions. This poker can be used only under the
applications for which it has been designed and according to these safety instructions:
1. Before working, make sure that the end piece of the transmission is correctly connected to the
motor's coupling.
2. Be sure the poker is well screwed to the flexible shaft (screwed to left).
3. Do not work with flexible shaft with big bends.
4. Do not overlubricate the shaft.
5. Do not keep working the poker out of the concrete more than 5 minutes.
6. Do not restrict the movement of the poker during the work.
7. Do not stop the poker inside the concrete.
8. Do not connect the transmission to the motor while is running.
9. When you connect the machine to a petrol engine, make sure that the revolutions of the motor
don't exceed 3000 rpm.
10. If the poker doesn't vibrate properly, knock softly the cap to the floor.
11 Change the wear parts to avoid damaging the internal parts. (Check wearing table for the poker)
en
12. Do the maintenance with the types and quantities of recommended lubricants.
13. Proper protective equipment should be used because the acoustic power level LWA of this
machine is between 91 and 98 dB (see the point 2.3 of this manual) according to ISO 3744 and
measured in the hose 2 meters away from the poker (with the poker hanging in the air).
14. Transmited vibration to the operator does not exceed 2,5 m/s
of this manual). Measured value according to ISO 5349 and measured in the hose 2 meters away
from the poker (with the poker hanging in the air) and being the uncertainty constant K=1 m/s2..
IN ADDITION, LOCAL COUNTRY ESTABLISHED ORDINANCES MUST BE RESPECTED.
5

OPERATION AND MAINTENANCE

Read item 3 GENERAL AND SPECIFIC SAFETY RULES

5.1 SHAFT CONNECTION TO THE POWER UNIT

Power unit is designed to facilitate a quick and safe connection to flexible shaft.
Connection procedure:
Connection possibilities
PETROL ENGINE-ELECTRIC MOTOR-FLEXIBLE SHAFT AND POKERS
8
VGR6, VGH5, VGE5, VYD, VHD, VLD - VPA, VPAME - TNR - ANR
Move the pin in the engine and introduce the coupling up to the pin is in the slop.
Length of transmission:................ 4 and 6 m: TNR 4m, TNR 6m
Diameter of transmission:............ Until diameter 70: ANR 25, ANR 38, ANR 48, ANR58
2
of acceleration (see the point 2.3