Bianchi IMPULSO RC Manual Del Usuario página 8

THRU-AXLE
WARNING!
Use caution and observe the following warnings.
Unlike quick-release systems, the thru-axles provided with this model are
screwed directly onto the frame and fork dropouts using an M12 screw.
Comply with the torques indicated on the thru-axles.
Female threads are housed in the frame and fork; the thru-axle with the
male thread has a specific length to enable safe assembly of the wheels.
(images 1B and 1C)
The use of a thru-axle other than the one provided may result in the
incorrect assembly of the wheel and may compromise the integrity of the
frame and fork.
WARNING!
Always use the thru-axles provided with the model. The use of thru-
axles other than those specified may cause the frame and/or fork
to break.
DANGER!
Incorrectly mounted wheels may result in falls and serious accidents.
If in doubt, contact your specialist retailer.
DANGER!
Always comply with the torque levels specified on the thru-axles.
Never exceed the maximum torque value indicated. Incorrect
tightening may damage the frame and fork.
SEAT POST CLAMP/EXPANDER
The seat post clamp/expander provided is designed specifically for use with the Impulso RC, PRO and COMP frames. Without this component, it is not
possible to lock the seat post in the desired position. (images 1D).
Pay close attention to the warnings given below. Failure to comply with the warnings and provisions contained in this data sheet exempts the manufacturer
from any liability.
To change the saddle height, lift the rubber cover on the frame to access the M5 screw on the clamp/expander; loosen this M5 screw and adjust the height
of the seat post.
1D
8
1B
1C
1D