Publicidad
Idiomas disponibles
Idiomas disponibles
Reading Tags
1. Hold the reader on the card, tag or smart device to be read.
2. For best results, the card, tag, or smart device should be parallel to
the D600 antenna.
3. Press the trigger button momentarily; the read indicator light turns
orange to indicate the D600 is pulling data from a tag.
4. Hold the reader steady until the read operation is complete (orange
LED turns to green).
By default, the reader will beep, vibrate, and the read indicator will
flash green to confirm a successful read. These default settings can be
changed by application commands and configuration cards.
The D600 will only read tags while connected to a host device.
However, if the trigger button is continuously pressed for 15 seconds,
it will initiate continuous reading.
The D600 can be configured to continuously read, initiated by a
secure tap command from an application.
READING TAGS
9
Publicidad
