Publicidad
Idiomas disponibles
Idiomas disponibles
3. Make sure that the fuel shut-off valve is open. The
fuel shut-off valve is open when the tab is in the
direction of the fuel hose.
4. Make sure that the drive system is engaged. Refer to
To engage and disengage the drive system on page
18 .
5. Put the cutting deck in the highest position. Refer to
To set the cutting height (TC 112) on page 20 or To
set the cutting height (TC 114) on page 20 .
To start the engine
1. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck (TC
to
112) on page 19 or To engage and disengage the
cutting deck (TC 114) on page 19 .
2. Sit in the seat in work position.
3. Apply the parking brake. Refer to
release the parking brake on page 19 .
4. Push the throttle control to the half throttle position
(A).
A
18
To apply and
B
5. Turn the ignition key to the start position. When the
engine starts, immediately release the ignition key.
The ignition key goes back to the ON (I) position
automatically when you release it.
CAUTION:
starter for more than 5 seconds at a
time. If the engine does not start, wait
15 seconds before you try again.
6. Let the engine operate at half throttle for 3–5 minutes
before you apply heavy load.
7. Push the throttle control to the full throttle position
(B).
A
CAUTION:
when the engine is at full speed causes
strain on the drive belts. Engage the cutting
deck before you put the throttle control in the
full throttle position.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged.
CAUTION:
out or push in the lever. Do not use middle
positions.
Do not operate the
B
To engage the cutting deck
Make sure that you fully pull
1903 - 004 - 18.12.2023
Publicidad
