IKRA IROM 600 Instrucciones De Manejo página 30

GB
ENGLISH
CAUTION
The perimeter wire must not cross. Max. The
maximum distance between the wires is 5 mm.
4. Make sure that the boundary wire is perfectly
straight in each corner and that all angles
formed by the boundary wire are 90° or more.
10 11
5. Gradients:
NOTE: Your mower is capable of safely
negotiating slopes of up to 35% (20°). Avoid
areas steeper than this.
12 13
Status of the LED light
does not light up
green lit
15
Flashing green
16
red flashing
17
4) Test the installation
Set the cutting height for the first mowing
operation to the maximum height (60 mm). Place
your mower in the working area and let it work
for a while. Then check the boundary wire and
whether the mower travels back to the charging
station along the boundary wire. If the mower
returns to the charging station successfully, the
installation has been completed successfully!
18 19
TIP
First operation
Position the mower behind the station at a 90° angle to
the boundary wire. Press the „Home" button and then
„OK". The mower will now travel the entire distance to the
station. This allows you to recognise problem areas.
19
CAUTION
To stop the mower, press the STOP BUTTON.
30
8
Cause
No power supply
The boundary wire is connected correctly;
the mower is fully charged
The mower is charging automatically
The boundary wire is not connected; OR the
boundary wire is disconnected
3) Connect the charging station to the power
source
CAUTION
Only connect the plug to the mains after the power supply
unit and perimeter wire have been connected correctly.
If you have laid the boundary wire correctly,
connect the power supply. The charging station
LED light lights up and is permanently bright
green. Check the LED status in the table to
ensure that the connection is OK.
14 15 16 17
Remedy
Ensure that the mains cable is correctly
connected to the charger and that the
charger is connected to a suitable power
supply.
Check that both ends of the boundary
wire are reliably connected to the cable
connection.
CAUTION
Default setting: On Tuesdays and Fridays, the robot mower
mows the edges first.
5) Quick start (Digital Tube Interface)
Display
Zeiteinstellung
Time setting
Passwort
Password setting
Ein-/Aus
Turn on/off
Mäh-Start
Start working
—
—
Bluetooth
WIFI
Ladezustand
Power
Bestätigung
Confirm
zur Ladestation
Back to station