IKRA IROM 600 Instrucciones De Manejo página 35

Error unknown • Restart the mower. Press START and then OK. If the error message is still displayed, contact
EE
Robot mower
locked (PIN
LOCK
entered
incorrectly too
often)
TROUBLESHOOTING
Defect
Mower does not start
LED light on charging
station does not light up
LED light on charging
station flashes red
Mower does not mow
properly
Mower starts at unusual/
wrong times
Mower gets stuck
8) Software update by USB stick
The software can be updated when new
versions are available. The latest software can
be downloaded from our website: www.ikra.
de Update via USB. Download and installation
instructions can be found below:
1. Search for the latest software version at:
www.ikra.de . Save the file to an empty
USB stick (flash drive) formatted with FAT32.
Delete all other files on the drive and check
the format. If the drive is not formatted in
FAT32, please reformat it.
2. Place the mower on a safe and level surface.
Press POWER ON/OFF,
and switch off the mower.
3. Turn the mower onto its back. Remove the
battery cover (see 9) 4.a-b) Insert the USB
drive (flash drive) into the port.
a customer service representative for assistance.
• Wait 10 minutes until the PIN can be entered again.
• Do not switch off the robot mower
• If the error still occurs, contact your specialist dealer
Cause
Mower or charging station is not connected
to the power supply
Perimeter wire is not connected or has been
cut/interrupted
Blades are worn
Date/time set incorrectly
Unsuitable terrain/obstacle
Removal
• Connect the power supply unit to a suitable
power source.
• Call a specialist if necessary
Connecting / repairing the perimeter wire
Replace blade
Set the correct date/time
• Adapt the terrain / obstacle to the
requirements of the robot mower
• Adjust the installation of the perimeter wire
accordingly
USB
Battery
cover
remove
4. Switch on the mower. The update will start
automatically. Wait until the display shows
OK, then remove the USB drive (flash drive)
and close the protective cover tightly.
5. The manual supplied with your mower is
based on the standard software at the time of
manufacture. Some new features/functions
in the new version may not be included in the
manual.
Software update (auto) via WLAN
This only works automatically if the robot mower
is connected to the WLAN.
9) Maintenance
Your mower works hard and needs to be cleaned
and checked from time to time. Some parts
must be replaced if they are worn. Switch off the
appliance before carrying out any maintenance
GB
ENGLISH
35