VALBERG FIH 60 MK 302C Instrucciones De Uso página 6

A
Using the appliance
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep expansion pipe short and straight.
• Do not reduce the size or restrict the expansion pipe.
• When using the expansion pipe always install the pipe pulled taut to minimize pressure
loss.
• Failure to observe these basic instructions will reduce the performance and increase
noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent person.
• Do not connect the ducting system of the hood to any existing ventilation system which
is being used for any other appliance, such as warmer tube, gas tube, hot wind tube.
• The angle of the bend of the expansion pipe should not be less than 120º; you must direct
the pipe horizontally, or, alternatively, the pipe should go up from the initial point and
should be led to an outer wall.
• After the installation, make sure that the cooker hood is level to avoid grease collection
at on end.
• Ensure the expansion pipe selected for installation complies with relevant standards and
is fire retardant.
Right
Ensure the exhaust ducting selected for installation complies with relevant standards and is
fire retardant.
WARNING:
For safety reason, please use only the same size of fixing or
mounting screws which are recommended in this instruction
manual.
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
Wrong
8 EN
A
Using the appliance
Installation without external opening
Recycling version
Contact your supplier to obtain active
carbon filters to transform the extractor
hood into a recycling hood.
Installing the active carbon filter (cassette)
• Check that the diameter of the active
carbon filter corresponds the outlet
diameter.
• If necessary, remove the pre-installed
diameter adapter.
• Position the active carbon filter on the
outlet and attach it in place by turning
anticlockwise.
Installing the active carbon filter (cut-out)
• The metal filter has to be removed
before the active carbon filter is
installed.
• To open the metal filter, press on
the locking device and pull the filter
downwards.
• Place the precut filter on top of the
metal filter. Hold in position using the
metal rods (supplied according to the
model).
• Replace the metal filter in its original
position.
NB
Make sure that the filter is properly attached; otherwise it
could become dislodged and cause a hazard.
The installation of a carbon filter reduces the extraction
power of the hood.
9 EN