VALBERG FIH 60 MK 302C Instrucciones De Uso página 8

B
Useful information
Troubleshooting
Fault Possible Cause
Fan switch turned off
Light on, but motor
Fan switch failed
does not work
Motor failed
House fuses blown
Light does not work,
Mains power cable is loose
motor does not work
or disconnected
One way valve and the
outlet are not tightly sealed
Oil leakage
Leakage from the
connection of chimney and
cover
Lights not working Broken or faulty bulbs
The distance between the
Insufficient suction cooker hood and the gas
top is too far
The Cooker hood The fixing screw is not tight
inclines enough
NOTE:
Any electrical repairs to this appliance must conform to
your local, state and federal laws. Please contact the service
centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when
opening the unit.
12
Solution
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable to power
outlet.
Switch power outlet on.
Take down the one way valve and
seal with sealant.
Take chimney down and seal.
Replace bulbs as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
EN
B
Useful information
Maintenance and cleaning
Caution:
Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the mains power supply.
Ensure that the cooker hood is switched off at the wall
socket and the plug removed.
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions to
ensure the best possible result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the
appliance cold especially when cleaning. Avoid leaving
alkaline or acid substances (lemon juice, vinegar etc.) on
the surfaces.
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g.weekly)
to ensure a long life expectancy. Dry with a clean soft cloth.
A specialized stainless steel cleaning fluid may be used.
NOTE:
Ensure that wiping is done along with the grain of the
stainless steel to prevent any unsightly crisscross scratching
patterns from appearing.
13 EN