Machine Operation
EN
Setting the Cleaning Controls
Insert the key, turn the main control on / off key to position '1' (Fig.A). The battery
charge-level indicator will illuminate for 5 seconds.
Set desired traction speed as required, depending on floor type and level of soiling
(Fig.B).
Middle speed is the optimum cleaning speed.
The TBL6055T is equipped with an electronic braking system.
Simply release the hand operated start / stop trigger and the machine will stop.
In an emergency, strike the Emergency Stop button. (Fig.C).
The machine will be disabled.
To reset, turn Emergency Stop button clockwise.
After re-setting the Emergency Stop button, to restart the machine, turn the main
control on / off key to '0' and then position '1'.
Free Wheel Function
The machine is equipped with a free-wheel function that will enable the operator to move the machine manually if required.
The motor brake is located on the right side of the machine near the rear wheel.
Pull the arm out (Fig.1). Swing to the disengaged position (Fig.2).
The motor brake will be fully disengaged. The machine will now be in full free wheel mode.
1
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE DISENGAGING BRAKE ARM.
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
Note: Drive functions on the machine will not work whilst in free-wheel mode.
Remember to re-engage the drive when you reach your final destination / before using the machine.
Specifications
Brush Motor
300 W
Protection Class
IPX4
Scrub Pressure Standard
24 kg
Traction Drive Motor
Net Weight
Gross Weight (Full)
141.15 kg
201.15 kg
Net Weight
Gross Weight (Full)
151.95 kg
211.95 kg
Model - TBL6055T (Traction Models)
Vac Motor
400 W
Brush Speed
140 RPM
Scrub Pressure Heavy
32 kg
250W
Sound Pressure
Level (LpA)
≤ 72 dB (A)
Sound Pressure
Level (LpA)
≤ 72 dB (A)
2
Brush Sizes
550 mm
Water Capacity
60 L
Dimensions
Width = 560mm (948mm) / Length = 1425mm / Height = 1120mm
50 Ah
Run Time
Maximum Climbing Gradient
1 hr 30 mins average
100 Ah
Run Time
Maximum Climbing Gradient
3 hrs average
86
C
Pad Sizes
Charger
508 mm
20 Amp
Fluid Flow
Hand Arm Vibration
0 - 2 L/Min
≤1.07m/s
Drive Speed
0-4km/h
Re-charge Time
Scrubbing 11 %
Re-charge Time
Scrubbing 11 %
B
A
2
2.5 hrs
5 hrs