Dometic WAECO DC-Kit1 Instrucciones De Montaje Y De Uso página 24

Installing and connecting the DC kit
Note the following safety instructions during installation:
A
NOTICE!
 Note the location of wiring harnesses, wiring and other compo-
nents within the installation area.
 Install the DC kit using the following instructions. Improper
installation of the DC kit can put the safety of the user at risk
and lead to irreparable damage to the DC kit or other devices.
 Disconnect all power supply lines to the individual components
and the roof air conditioner.
Observe the following safety instructions for the electrical connections:
A
NOTICE! Risk of short circuit!
 First, disconnect the 230 V external power supply to the
caravan.
 Disconnect the earth connection to the supply battery.
 Disconnect the connection to the starter battery.
 If you have to feed cables through metal walls or other walls
with sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Ensure the 12 V cables are especially well-protected.
 Check whether you need to fit any additional fuses.
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Lay the cables so that they cannot be tripped over or dam-
aged.
Observe the following instructions when selecting the location for installing
the components:
 Make sure the cables are of the correct length.
 Choose a well-ventilated installation location near the supply battery.
7.1 Preparing the installation
➤ Disconnect the following voltage supplies in the vehicle:
– Positive battery terminal
– External voltage supply
24
DC-Kit1
EN