MSW Motor Technics MSW-GDOOR-005B Manual De Instrucciones página 55

Note:
Wiring: the black wire of main engine 1 is connected to the left side of MOTOR1; The brown

cable of host 1 connects to the right side of MOTOR1.The black cable of main engine 2 connects
to the left side of MOTOR2; The brown cable of main engine 2 connects to the right side of
MOTOR2.
In single-door mode, the host connects to MOTOR1.

If the gate suddenly stops during movement setting, please increase the resistance force.

If the gate didn't stop when meets the obstacles during movement setting, please appropriately

reduce the resistance force.
Installer must redo movement setting after modifying the "SPEED" trimmer.

9.5 Trimmers Setting
Obstacle Sensibility Trimmer
To adjust the sensitivity of obstacle -- turn clockwise to increase, counterclockwise to reduce the
sensitivity of obstacle. If there are environmental effects, such as heavy winds, adjust the trimmer
according to environment.
Slow Speed Distance Trimmer
To adjust slow speed distance -- turn clockwise to increase, counterclockwise to decrease slow speed
distance. Please do not set very short slow speed distance, to avoid the gate collision.
Gate Moving Speed Trimmer
To adjust gate moving speed -- turn clockwise to accelerate, counterclockwise to slow down. The
trimmer can be adjusted to change the opening and closing travel time. This adjustment must be
finished before travel setting.
Turning counterclockwise: reduce
Turning clockwise: increase
FORCE
Obstacle Sensibility Trimmer
EN
SLOW DOWN
Slow Speed Distance Trimmer
Figure 15
SPEED
Gate Moving Speed Trimmer