Bosch GKE 35 BCE PROFESSIONAL Instrucciones De Servicio página 26

1 609 929 J52.book Seite 9 Montag, 27. März 2006 10:51 10
Replacing/Changing Chain
and Chain Bar
Fit the chain and chain bar as described in "Assem-
bly and Tensioning Chain".
The circular groove of the chain bar will wear partic-
ularly on the lower edge with time. When replacing
the chain turn the chain bar 180° to allow even wear,
thus extending chain bar life.
Remount the chain tensioning catch 17 on the chain
bar.
Check drive sprocket 22. If it is worn out or damaged
due to strain, have it exchanged by an authorized
Bosch service agent.
Sharpening Chain
Have your chain sharpened professionally at your
Bosch approved service agent or sharpen the chain
yourself using the Bosch sharpening kit or a Dremel
power tool with the appropriate grinder (1453), both
available at your Bosch approved service agent. Fol-
low the sharpening instructions supplied with the
sharpening kit.
Checking the Automatic Oiler
Proper functioning of the automatic oiler can be
checked by running the chain saw and pointing the
tip of the chain bar towards a piece of cardboard or
paper on the ground. Caution: Do not touch the
ground with the chain. Ensure safety clearance of
20 cm. If an increasing oil pattern developes, the au-
tomatic oiler is operating fine. If there is no oil pat-
tern, despite a full oil reservoir, see "Fault Finding" or
contact your Bosch approved service agent.
26 • 1 609 929 J52 • TMS • 15.03.06
Accessories
Chain
for chain bar 350 mm
for chain bar 400 mm
Chain bar DOUBLE GUARD
350 mm
............................................................
400 mm
............................................................
Additional accessories
Chain sharpening/cleaning kit
Chain saw oil, biologically degradable
1 l
........................................................................
Protective goggles
......................................
Protective goggles
for persons wearing glasses
Cleaning/Storage
Clean the moulded plastic housing of the chain saw
using a soft brush and clean cloth. Do not use water,
solvents or polishes. Remove all debris, especially
from the motor cooling vents 26.
Remove and brush clean the cover plate 15, chain
and chain bar after 1 to 3 hours of use.
Clean the area under the cover plate 15, the drive
sprocket 22 and chain bar assembly using a soft
brush. Clean oil outlet 20 with a clean cloth.
When the chain tensioning mechanism in the cover
plate 15 is sluggish, take off the dust protection
cover 28, turn the locking knob 14 as well as the ten-
sioning ring 13 against each other so that deposits
within the mechanism are loosened and can fall out
to the bottom. Carefully tap out the cover plate 15.
When the mechanism is heavily gummed up, clean
with a soft brush or compressed air. Do not use tools
by any means (see figure
If the chain saw is to be stored for a longer period of
time, clean chain and chain bar.
Store in a secure, dry place out of the reach of chil-
dren. Do not place other objects on the chain saw.
To prevent leakage ensure machine is left in a hori-
zontal position (oil filler cap 4 uppermost).
When storing machine in original packaging the oil
tank must be completely emptied.
English - 9
2 604 730 000
................................
2 604 730 001
................................
2 602 317 050
2 602 317 051
2 607 000 180
..............
2 607 000 181
2 607 990 041
2 607 990 037
..................
).
K