CORBERO CLVM6021X Manual De Instrucciones página 20

Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case remove
the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed again under the rear edge
of the top (b).
Built-In Installation
Step 1. Selecting the best location for the dishwasher
The installation position of
hose and power socket
Illustrations of cabinet dimensions and installation position of the dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
the dishwasher should be near the existing inlet and drain
.
90 °
Electrical, drain Electrical, drain
820mm 820mm
and water supply and water supply
line connection line connection
580mm 580mm
Space between cabinet Space between cabinet
bottom and floor bottom and floor
for 60cm model
600 mm(
mm for 45cm model
450 (
20
(for the integrated model)
90 °
80 80
100 100
)
)
a
a
b
b