Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1.
Close
the door,
2.
Within 60 seconds after the appliance was switched on press the program
or more than 5 seconds to enter the water softener setting mode.
3. Press the
program buttonagain
environment, the
H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the
WATER HARDNESS
German
German
French
French
British
British
dH
dH
fH
fH
Clarke
Clarke
0 - 5
0 - 9
0 - 6
6 - 11
10 - 20
7 - 14
12 - 17
21 - 30
15 - 21
18 - 22
31 - 40
22 - 28
23 - 34
41 - 60
29 - 42
35 - 55
61 - 98
43 - 69
°
°
1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
The
factory
setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0 litres of water,
the energy consumption increases by 0.02 kWh and the program extents by 4
minutes.
switch
on the appliance;
to select the proper set according to your local
setting
will change in the following sequence:
Water softner
level
Mmol/l
Mmol/l
0 - 0.94
H1->Rapid Light bright
H2->90 min Light bright
1.0 - 2.0
2.1 - 3.0
H3->Rapid, 90 min Light bright
H4->Glass Light bright
3.1 - 4.0
4.1 - 6.0
H5->Rapid, Glass Light bright
6.1 - 9.8
H6->90 min, Glass Light bright
°
setting mode
.
Regeneration occurs
every X program
sequence
No regeneration
6
Salt consumption
(gram/cycle)
1)
10
5
3
2
1
0
9
12
20
30
60