Publicidad
Idiomas disponibles
Idiomas disponibles
Using Built-in AVNavigator
Connecting to the network through
LAN interface
Internet
Modem
Computer
LAN cable (sold separately)
LAN
(10/100)
LAN
( 10/100 )
Connecting to a wireless LAN
Wireless connection to the network is possible through a
wireless LAN connection. Use the separately sold AS-WL300
for connection.
Router
• Use only the furnished accessory connecting cable.
• Certain settings are required to use a wireless LAN
WAN
converter (AS-WL300). For instructions on making these
settings, see the operating instructions included with the
LAN
wireless LAN converter (AS-WL300).
1
2
LAN
(10/100)
DC OUTPUT
3
for WIRELESS LAN
(
OUTPUT 5 V
0.6 A MAX
)
Router
DC 5V
Ethernet
WPS
Wireless LAN converter (AS-WL300)
Plugging in the receiver
After connecting to a LAN, connect the power cord of the
receiver to a power outlet.
CAUTION
• Handle the power cord by the plug part. Do not pull out
the plug by tugging the cord, and never touch the power
cord when your hands are wet, as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, or other object on the power cord or pinch the
cord in any other way. Never make a knot in the cord or tie
it with other cables. The power cords should be routed so
that they are not likely to be stepped on. A damaged power
cord can cause a fire or give you an electric shock. Check
the power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent service
company for a replacement.
• Do not use any power cord other than the one supplied
with this unit.
• Do not use the supplied power cord for any purpose other
than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g., when on vacation.
• Make sure the blue uSTANDBY/ON light has gone out
before unplugging.
LAN
(10/100)
DC OUTPUT
1
for WIRELESS LAN
Plug the supplied power cord into the AC IN
(
OUTPUT 5 V
0.6 A MAX
)
socket on the back of the receiver.
2
Plug the other end into a power outlet.
Modem
Internet
Turning the power on
Press uSTANDBY/ON to switch on the receiver and your
WAN
computer.
Wait a few minutes after turning the power on before
performing the following operation.
S
C O
STANDBY/ ON
PHONES
MCACC
SETUP MIC
3
Publicidad
