JMA MOVE Manual De Usuario página 8

JMA
MOVE
3. INSTALLATION AND PREPARATION OF THE MACHINE
Installation of this machine presents no difficulty whatsoe-
ver, but you should not attempt to install, adjust or operate
the machine without reading this user manual first. The
machine leaves our factory ready for use and only needs to
be calibrated for the tools that are going to be used.
3.1 ENVIRONMENTAL CONDITIONS IN THE WORKSHOP
- The machine should be used in places with an ambient
temperature of between 0º and 40º C, a relative humidity of
less than 50–60% and good lighting so that it can be opera-
ted and maintained correctly.
1. Use of the machine in explosive atmos-
pheres or in the presence of flammable
liquids or gases is strictly prohibited.
3.2 CHARACTERISTICS OF THE LOCATION FOR INSTALLA-
TION
- Place the machine on a solid horizontal work surface capa-
ble of properly supporting its weight (12 kg).
- The height of the work bench should be adapted to the
height of the operator. The machine should be at the same
height as the pelvis of the operator.
- We recommend leaving 30 cm of free space around the
machine for normal operation and maintenance.
1. The voltage connected to the machine
should be the same as that connected
to the workshop and the workshop
should have an earthing connection
and differential circuit breaker.
3.3 PREPARATION OF THE MACHINE
After positioning the machine on the work bench, the parts
that come packaged separately will need to be assembled
by the customer as follows:
- Screw the head control lever into its corresponding posi-
tion.
- The machine can be secured to the work bench using the
KEY CUTTING MACHINE
anchoring tool included with the accessories. Follow the
steps below to secure the machine:
See Figure 1
1.
1) Very carefully roll the machine onto its rear side.
2) Attach the tool (Z) to the machine using the two screws (T)
included with the accessories.
3) Roll the machine back upright and secure it to the work
bench using the grooves at the ends of the tool.
- Connect the power cord to the electrical power supply.
Switch off the machine and unplug the
power cord.