Descargar Imprimir esta página

MSW Motor Technics MSW-PG-113 Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 78
8. Oil filler plug
9. Oil drain nut
10. Engine switch
11. Choke lever
12. Pull cord
13. Petrol cock
14. Wheels
15. Carry handle
16. Rubber foot
17. Spanner
18. DC connecting cord
19. Wheel shaft
20. Air filter set
21. Spark plug
22. Spark plug wrench set
3.2.
Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
3.3.
Assembling the device
Wheel assembly (B4-B5)
1. First place one end of the wheel shaft (item 19) through the hole in the frame and secure it with a nut
and washer.
2. Put the shaft sleeve through the other end of the wheel shaft. Then place the wheel and secure it by
the nut and the washer.
3. Assemble the left side wheel with same procedures as above.
Important:
The inner wheel should be inflated for it has been shipped out with lower pressure (max. gauge pressure 3
bar/0.3 MPa).
Rubber feet assembly (B7-B8)
Hold the foot (item 16) against the frame as shown. First place the bolt through the hole into the frame
and the hole in the foot and secure it with a nut. Then secure other three bolts and nuts with same
procedure.
Transport handle assembly (B6)
Place the carry handle (item 15) holder against the frame as shown. Place the bolt through the hole into
the frame and the hole in the handle holder. Then secure it with a nut. Then secure the other bolt with
same procedure.
The user can adjust the position of carry handle.
Important: Electrical safety
Electric supply cables and connected equipment must be in perfect condition.
The generator is to be operated only with equipment whose voltage specifications conform to the
generator's output voltage.
Never connect the generator to any other power supply.
Keep the cable length to the consumer as short as possible.
EN

Publicidad

loading