MSW Motor Technics MSW-PG-113 Manual De Instrucciones página 24

EN
Connecting to earth
The housing is allowed to be connected to earth in order to discharge static electricity. To do this, connect
one end of a cable to the earth connection (5) on the generator and the other end to an external earth (for
example an earth rod).
3.4. Device use
Before starting the generator.
You must fill up with engine oil (B12) and fuel before you can start the engine.
Check the fuel level and top it up if necessary.
Make sure that the generator has sufficient ventilation.
Make sure that the ignition cable is secured to the spark plug.
Inspect the immediate vicinity of the generator.
Disconnect any electrical equipment which may already been connected to the generator.
Permissible ambient temperature – 10 to + 40°C, max. altitude above sea level 1000 m, relative
humidity:90 %(noncondensing)
Never use the generator in dusty area.
Starting the engine (reversing starter)
Open the petrol cock (13) by turning it up.
Move the engine switch (10) to position "I".
Move the choke lever (11) to position IØI.
Start the engine with the pull cord (12) by pulling the handle forcefully. If the engine does not start, pull
the handle again.
Push the choke lever (11) back again after the engine has started.
Important!
When starting with the pull cord, the motor may recoil suddenly as it starts up, resulting in hand injuries.
Wear protective gloves when starting the equipment.
Connecting appliances to the generator
Connect the equipment you want to use to the socket outlets (3).
Important!
Never connect the generator to the domestic power network as this may result in damage to the
generator itself or to other electrical appliances in your home.
Switch off the machine immediately and contact your service station:
If the generator is making unusual vibrations or noise.
If the engine is overloaded within rated load range or misfires.
Note: Some electrical appliances (power jigsaws, drills, etc.) may have a higher level of power
consumption when used in difficult conditions or starting.
Use the supplied DC connecting cable to make connection to 12VDC powered appliance.
Important!
The DC output of the generator is not treated by a precise electric circuit.
Never use it to power any precise DC instrument.
Important!
When using the generator to powering a heating device. Please do keep the powered heating device far
from the generator.
Switching off the engine
Before you switch off the generator, allow it to run briefly with no appliances so that it can "cool down".
Move the Engine switch (10) to position "O".
Close the petrol cock.
Overload cut-out for socket-outlets
Important!