Publicidad
Idiomas disponibles
Idiomas disponibles
3. Use combi-wrench (provided) to loosen the screw of
EN
dust removal cover (O-1) to open it (Fig. O1).
4. Clean up the sawdust and chips accumulated in the
cooling fin by using compressed dry air, blow it from
the opposite side air inlet (O-2) (Fig. O2).
O-1 Dust Removal Cover
GUIDE BAR MAINTENANCE
When the guide bar shows signs of wear, disassemble
it from the chain saw power head and reverse it for
reassembly (Fig.P1), in which case it will distribute the
wear for maximum bar life.
The bar should be cleaned (including bar rails (P-1) and
lubricating hole (P-2) every day of use and checked
for wear and damage (Fig. P2). Feathering or burring of
the bar rails is a normal process of bar wear. Such faults
should be smoothed with a file as soon as they occur. A
bar with any of the following faults should be replaced.
Wear inside the bar rails which permits the chain to lay
over sideways.
◾
Bent guide bar.
◾
Cracked or broken rails.
◾
Spread rails.
The guide bar has a sprocket at its tip. The sprocket must
be lubricated weekly with a grease syringe to extend the
guide bar life (Fig. P3 & P4). Turn the nose sprocket (P-3)
while pumping the translucent yellow, translucent red or
translucent grease into the lubricating hole (P-4) until the
entire sprocket has new grease. Do not push dirt into the hole.
P-1 Bar rails
P-2 Lubricating Hole
CHAIN MAINTENANCE
Use only low-kickback chains on this saw. This fast
cutting chain will provide kickback reduction when
properly maintained.
A properly sharpened saw chain cuts through wood
effortlessly, even with very little pressure. Never use a
dull or damaged saw chain. A dull saw chain cutter leads
to increased physical strain, increased vibration load,
unsatisfactory cutting results, and increased wear.
For smooth and fast cutting, the chain needs to be
maintained properly. The chain requires sharpening when
the wood chips are small and powdery, the chain must be
forced through the wood during cutting, or the chain cuts
to one side. During maintenance of your chain, consider
the following:
12
56 VOLT LITHIUM-ION CORDLESS TOP HANDLE CHAIN SAW — CSX3000
O-2 Air Inlet
P-3 Sprocket
P-4 Lubricating Hole
◾
Improper filing angle of the side plate can increase the
risk of a severe kickback.
◾
Depth gauge clearance. Too low increases the potential
for kickback. Not low enough decreases cutting ability.
◾
If cutter teeth have hit hard objects, such as nails and
stones, or have been abraded by mud or sand on the
wood, have the chain sharpened by a qualified service
technician.
NOTICE:
it is recommended to have sharpening and
maintenance of the saw chain performed by authorized
service centers.
TRANSPORTING AND STORING
◾
Do not store or transport the chain saw when it is
running. Always disconnect the power plug before
storing or transporting.
◾
Always place the guide bar sheath on the guide bar
and chain before storing or transporting the chain saw.
Use caution to avoid the sharp teeth of the chain.
◾
Clean the chain saw thoroughly before storing. Store
the chain saw indoors, in a dry place that is locked
and/or inaccessible to children.
◾
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Protecting the environment
WEEE (Waste Electrical and Electronic
Equipment) Do not dispose of electrical
equipment, used battery and charger into
household waste! Take this product to an
authorized recycler and make it available
for separate collection. Electric tools must
be returned to an environmentally
compatible recycling facility.
Publicidad
