Publicidad
Idiomas disponibles
Idiomas disponibles
5.2
MINIMUM PANEL HEIGHTS
Refer to the table for the values of the minimum heights of the panels relative to the chain motors in the bottom hung inward
opening version.
Chain stroke "C"
5.3
OPERATING TEST
ATTENTION! Carry out the first maneuver of the window during the closing phase.
Press the control button and close the window, checking that:
a. The window is completely closed. If it is not, check that the gap between the window and the frame is bigger than or equal
to 0 mm. If necessary, insert spacers so as to obtain the correct gap.
b. The chain is perfectly vertical to the window frame. If necessary adjust the fixing bracket by using the screws and slots.
Having reached the correct closing position, press the control button and open the window in order to check that the actuator
runs freely over the full travel set up.
Having achieved the required opening run, press the control button again to close the window. Once the window has completely
closed, check that the screws, supports and fixings are tightened correctly, and that the seals are sufficiently compressed.
120mm
300mm
350mm
400mm
INDICATION OF DIMENSIONS
Motor rotation pivot
50
Panel rotation hinge
13.5
H min panel
450mm
750mm
1050mm
1400mm
39
Publicidad
