Publicidad
Idiomas disponibles
Idiomas disponibles
12. ENVIRONMENTAL PROTECTION
The actuator contains non-recyclable parts inside (plastic materials and electronic parts) that are not part of normal waste. They
must be disposed of properly. For any questions, please contact the waste disposal company.
13. FAQS (FREQUENTLY ASKED QUESTIONS)
Question
Does the actuator not
work?
The actuator does not
perform the desired stroke
The actuator ripped off the
screws
46
Causes
No voltage
Voltage present
Trimmer in M or A position
Synchronized
assembly
misalignment
The opening width is not as
desired
The limiting arm does not
allow the complete stroke to
the actuator
The
connections
inward
opening window) are no
longer fixed to the window.
Solution
Check that the status of the differential or the circuit breaker
is ON.
Cable probably not connected. Check the electrical connections
from the switch to the actuator.
Check that the actuator voltage is consistent with the detected
voltage.
Synchronize or schedule or set a stroke.
See synchronization chapter "7.
SYNCHRONIZATION".
Check according to chapter "7.3
that the trimmer is positioned on the desired stroke.
Unhook the chain from the coupling and check that the limiting
arm allows the actuator to run completely. If this is not the case,
adjust the limiter arm so that the actuator performs the entire
stroke.
Check that suitable fasteners have been used.
Check that during closing the chain is perfectly perpendicular to
the window. If this is not the case, check that the installation has
been carried out according to sequence 5.1.
A C T U A T O R
Chain strokes adjustment"
Publicidad
