Publicidad
Idiomas disponibles
Idiomas disponibles
TO REPLACE
MOWER
BLADE
DRIVE
BELT
The mower blade drive belt may be re-
placed without tools.
Park the tractor on
level surface.
Engage
parking brake.
BELT REMOVAL
-
1. Remove
mower from tractor
(See "TO
REMOVE
MOWER"
in this section
of
manual).
2. Work belt off both mandrel
pulleys and
idler pulleys.
3.
Pull belt away from mower.
BELT INSTALLATION
-
1. Work belt around
both mandrel
pulleys
and idler pulleys
2.
Make sure belt is in all pulley grooves
and inside all belt guides.
3.
Install mower
(See ',To Install Mower" in
this section
of this manual).
Mandrel
Idler Pulleys
\
Mandrel
Pulley
TO CHECK
BRAKE
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete
or paved surface, then
brake must be serviced.
You may also check brake by:
1.
Park tractor on a level, dry concrete
or
paved
surface,
depress
clutch/brake
pedal
all the way down
and engage
parking
brake.
2.
Place gear shift lever in neutral (N) posi-
tion.
The rear wheels
must lock and skid when
you try to manually
push the tractor forward.
If the rear wheels
rotate,
then
the
brake
needs
to be serviced.
Contact
a Sears
or
other qualified
service
center.
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor
on level surface.
Engage
parking
brake.
For assistance,
there
is a
belt installation
guide decal on bottom
side
of left footrest.
BELT REMOVAL
-
1. Remove
mower
(See ',TO REMOVE
MOWER"
in this section
of manual).
NOTE:
Observe
entire motion drive belt
and position
of all belt guides
and keep-
ers.
2,
Remove
belt from stationary
idler and
clutching
idler.
3,
Remove
belt downward
from around
engine pulley.
4.
Pull belt slack toward
rear of tractor.
Remove
belt upwards
from transaxle
pulley by deflecting
belt keepers.
5.
Remove
belt from center span keeper
and pull belt away from tractor,
BELT INSTALLATION
-
1, Carefully
work new belt down between
transaxle
belt keepers
and onto the
input pulley.
2. Slide belt into the center span keeper.
3.
Pull belt toward front of tractor
and roll
around the top groove
of engine
pulley,
4.
Install belt through
stationary
idler and
clutching
idler.
5.
Make sure belt is in all pulley grooves
and inside all belt guides and keepers.
6.
Install mower
(See "TO INSTALL
MOWER"
in this section
of manual).
Engine
Clutching
Center
.Span
Keeper
Stationary Idler
Transaxle
22
Publicidad
