Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSAXLE
GEAR SHIFT LEVER
NEU-
TRAL ADJUSTMENT
The transaxle
should
be in neutral when
the gear shift lever is in neutral
(N) (lock
gate) position.
The adjustment
is preset
at the factory;
however,
if adjustment
is
needed,
proceed
as follows:
1, Make sure transaxle
is in neutral
(N).
NOTE: When the tractor
rear wheels
move
freely, the transaxle
is in neutral.
2.
Loosen
adjustment
bolt in front of the
right rear wheel.
3.
Position
the gear shift lever in the neu-
tral (N) position.
4.
Tighten
adjustment
bolt securely.
NOTE;
If additional
clearance
is needed
to get to adjustment
bolt, move mower
deck height to the lowest position.
Neutral Lock date
dearshift
/
-._
1
Adjustment Bolt
TO ADJUST
STEERING
WHEEL
ALIGN-
MENT
If steering
wheel
crossbars are not
horizontal (left to right) when wheels are
positioned straight forward, remove steer-
ing wheel and reassemble
with crossbars
horizontal. Tighten
securely.
FRONT
WHEEL
TOE-IN/CAMBER
The front wheel toe-in
and camber
are not
adjustable
on your tractor,
If damage has
occurred to affect the front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE
WHEEL
FOR REPAIRS
1. Block up axle securely.
2.
Remove
axle cover, retaining
ring and
washers
to allow wheel removal
(rear
wheels have a square key - Do not lose).
3.
Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in
rear wheel hub and axle.
Insert square
key.
4.
Replace
washers
and snap retaining
ring securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks, purchase
and
use tire sealant
from Sears. Tire sealant
also prevents
tire dry rot and corrosion.
tashers
Oetaining
Oing
Axle
Cover
I
Square Key
_
(Oear
theel Only)
TO START
ENGINE
WITH A WEAK
BAT-
TERY
_,WARNING:
Lead-acid
batteries
generate
explosive gases.
Keep sparks,
flame and smoking
materials away from
batteries.
Always
wear eye protection
when around batteries.
If your battery
is too weak to start the en-
gine, it should be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section
of
this manual).
If "jumper cables" are used for emergency
starting,
follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system.
The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER
CABLES
-
1. Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking care not to short
against tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other end of the BLACK
cable (D) to good chassis
ground,
away from fuel tank and battery.
teak or Dead
CullyCharged
Battery
Battery
TO REMOVE
CABLES,
REVERSE
ORDER
-
1, BLACK
cable first from chassis
and
then from the fully charged
battery.
2. RED cable last from both batteries.
23
Publicidad
