Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BA'I-rERY
_I_WARNING:
Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time.
Before connecting
battery,
remove
metal bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1. Lift seat pan to raised
position.
2.
Disconnect
BLACK
battery
cable first
then RED battery
cable and carefully
remove
battery from tractor.
3.
Install new battery with terminals
in
same position
as old battery.
4.
First connect
RED battery
cable to
positive
(+) terminal
with hex bolt and
keps nut as shown.
Tighten
securely.
Slide terminal
cover over terminal
5.
Connect
BLACK
grounding
cable to
negative
(-) terminal
with remaining
hex bolt and keps nut. Tighten
securely.
Seat
Label
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO
REMOVE
HOOD
AND
GRILL
AS-
SEMBLY
1.
Raise hood.
2.
Unsnap
headlight
wire connector,
3.
Stand
in front of tractor.
Grasp
hood at
sides, tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood, be sure to re-
connect
the headlight
wire connector.
\\
Hood
/
\
_
_
,/\
Headlight Wire
/',--',, /,_.\
Connector
Terminal
Cover
//Keps
Nut
"'-
Hex
Bolt
Positiv_
(Red)
Cable
Negative (Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1.
Raise hood.
2.
Pull bulb holder out of the hole in the
backside
of the grill.
3.
Replace bulb in holder and push bulb
holder securely
back into the hole in
the backside of the grill.
4.
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring may cause
your tractor to run poorly, stop running,
or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts section.
ENGINE
TO
ADJUST
THROTTLE
CONTROL
CABLE
The
throttle
control
has
been
preset
at
the factory
and adjustment
should not be
necessary
Check
adjustment as described
below before loosening cable. If adjustment
is necessary,
see engine manual.
TO ADJUST
CHOKE
CONTROL
The choke control has been preset
at the
factory and adjustment
should not be neces-
sary. If adjustment is necessary, see engine
manual.
TO ADJUST
CARBURETOR
Your carburetor has been preset at the factory
and adjustment
should
not be necessary.
However, minor adjustment may be required
to compensate
for differences
in fuel, tem-
perature, altitude or load. If the engine does
need adjustment,
see engine manual.
24
Publicidad
