Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Door Reversibility
Before connecting the appliance to the power supply, you should check whether the
door swing must be changed from right (as delivered) to left, if this is required by the
installation location and the usability.
WARNING!
▶ The appliance is heavy. You need two persons to carry out the door reversibility.
▶ Before any operation, first unplug the appliance from the mains
▶ Do not tilt the appliance more than 45°C to prevent damage of the refrigeration
system.
Assembly steps
1. Provide necessary tool.
2. Unplug the appliance.
3. Remove the upper hinge cover 1 and unscrew the upper hinge (three screws) on
right side 2.
4. Unplug the connection cable
5. Lift the loose refrigerator door carefully off the middle hinge.
6. Remove the middle hinge.
7. Remove the small cover of the front panel from left to right side.
8. Turn the door upside down and unscrew the cover (1). Take out the new cover (2)
from the necessary bag and screw them to opposite side.
9. Change the positions of the blanking plugs and the screw on the side.
10. Screw the middle hinge to the left side of the appliance. Pay attention to invert-
ing the pivot of the middle hinge, ensuring that the side with the gasket is facing
upwards
11. Lift the upper door carefully on the middle hinge. And be sure the pivot fits into
the hinge barrel of the lower door.
12. Take out the new upper hinge and hinge cover from the accessary bag. Put the
connection cable through the upper hinge and fix the upper hinge with three screws
on left side of appliance. And the put the hinge cover over the hinge.
13. Plug in the connection cable.
14. Replace front panel and fix it with five screws.
After the change of the door, check if the door seals are located properly on the
housing and all screws are tightened well.
42
Installation
Publicidad
