Publicidad
Idiomas disponibles
Idiomas disponibles
mnsta lation nstructions
GENERAL
o See Dimensions
and Clearances
in this section
for
all rough-in
and spacing
dimensions.
These dimen-
sions must be met for safe use of your range.
The
location of the electrical
outlet and pipe opening
(see
Gas
Pipe
and Electric
Outlet
Locations)
may
be
adjusted
to meet specific
requirements.
o The range may be placed with 0" (0 cm) clearance
(flush) at the back wall and side wails of the range.
LOCATION
Do not locate
the range where
it may be subject
to
strong drafts. Any openings
in the floor or wall behind
the range should
be sealed.
Make sure the openings
around
the base of the range that supply fresh air for
combustion
and ventilation
are not obstructed
by car-
peting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household
items, is heavy
and can settle into soft floor coverings
such as cush-
ioned vinyl or carpeting.
Use care when moving
the
range on this type of flooring.
It is recommended
that
the following
simple
and inexpensive
instructions
be
followed
to protect your floor.
The range should
be installed
on a sheet of plywood
(or similar
material).
When the floor covering
ends at
the front of the range, the area that the range wilt rest
on should
be built up with plywood
to the same level
or higher
than the floor covering.
This will allow the
range to be moved for cleaning
or servicing.
MODEL AND SERIAL NUMBER LOCATION
Depending
on your range,
you'll find the model
and
serial
numbers
on a label on the front frame
of the
range,
behind
the storage
drawer,
broiler
drawer
or
kick panel.
TOOLS YOU WILL NEED i ::
i :i
::::::::::::
° Phillips and flat-blade
screwdrivers
i:I
"Pencil
and ruler
.....
: :: ::
o Two pipe wrenches
(one for backup)
o 1%" open-end
or adjustable
wrench:
Nut drivers or wrenches:
3116" and lt4":i: :
:: i
o Pipe joint sealant
or UL-approved
pipe thread
tape
with Teflon*
that resists
action
of natural
and LP: ::
gases
:
: ::
° Flexible
metal
appliance
connector
(1/2 _' I_D.). A
5-foot
(i.5
m) length
is recommended
for ease of:
installation
but other lengths
are acceptable.
Never
use an old connector
when installing
a new range.
° Flare union adapter for connection
to gas supply line
(3/4" or t/2" NPT x t/2"
I.D.)
• Flare union adapter
for connection
to pressure
regu-
lator on range (1/2" NPT x 1/2" I.D.)
*Teflon: Registered trademark of DuPont
PREPARATION
o Remove
all tape and packaging.
Lift up the cooktop
(on models with dual burners)
and remove any pack-
ing material under it. Make sure the dual burners are
properly
seated and level.
• Remove
plastic film that covers
some chrome
parts
(around oven door, side trim).
o Take the accessory
pack out of the oven.
° Check
to be sure
that no range
parts
have come
loose during shipping.
28
Publicidad
