Publicidad
Idiomas disponibles
Idiomas disponibles
(C_o_Ve_ti_g
tO
L_
_S
(or Converting
Back to Natural
Gas from
LP)
This range leaves the factory set for use with natural gas.
If you convert to LP gas, keep these instructions
and ori-
fices in case you want to convert back to natural gas.
Prepare the Range for Conve_'sion
CAUTiON--Before
converting
the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical
power to the range.
If range has not yet been connected
to gas supply, or
if flexible
connection
was made, range may be pulled
out from the wall to make conversion
easier.
TooDsRequired:
• T-IO Torxdriver
(for sealed burners)
o 1/2" and 3/4" open-end
wrench
o Flat blade screwdriver
(small)
o Nut drivers or wrenches:
7ram, 5/16" or a small
adjustable
(depending
on the size of the spuds)
$2÷@ t
Convert The Pressure Reguaator
i
ARNING:
Do not remove
the
pressure
regu-
]
lator from
the range.
1
1. For models
equipped
with sealed
burners,
remove
the storage drawer, broiler drawer
or kick panel and
locate the pressure
regulator
at rear of the range.
Access Cover
On some models, you may have to remove an access
cover also.
For models
equipped
with dual burners,
remove
the
cooktop
and locate the pressure
regulator
at right rear
of range.
2. Follow the directions
in A or B, that match your reg-
ulator type.
DuamBurner Models
(models
with lift-up cooktops)
If it is regulator
A:
1. Use a coin to remove
the cap from the pressure
regulator.
2. Turn
the
cap
over
and
hook
it into
the
slots.
The type of gas to be used should
now be visible
on the top of the cap.
37
Sealed Burner Models
(models without
lift-up cooktops)
if it is regulator
B:
1. Unscrew
the plastic-protected
hex-nut cap from the
regulator.
2. Carefully
pry
the
protective
plastic
cap
off
the threaded
metal
cap.
Gently
pull the plastic
washer
off the threads
on the other
side of the
metal cap.
3, Push the plastic
cap onto the end of the metal cap
displaying
the type of gas you are converting
to.
Press the attached
plastic washer
onto the threads
on the other side of the metal cap.
4. Screw the hex-nut
cap back into the regulator.
Do
not overtighten.
SEALED BURNERS
Levershownclosed.
PUSH DOWN
TO OPEN.
Gas
Flow
Do not remove
Cap Assembly
this protective cap
except for conversion
(continued next page)
Publicidad
