DAZE Dazebox Home Manual De Instalación página 18

12 - RFID card configuration
All models of Dazebox Home come equipped with an RFID reader that allows the user with a card to authenticate and start
charging on a locked charger. The operation of the RFID reader requires a stable internet connection for the charger.
Note: offline usage is only allowed for specific CPOs.
Inside the Dazebox Home packaging, you will find 3 RFID cards to enable for use. The activation of a card is done through the
EN
app by associating the card's serial number (see fig. C) with the network in which the charger is located. Once the association
with the network is complete, you can then associate the card with a user on the network.
Note: within the same network, a card can only be associated with one user.
C
13 - Troubleshooting
If Dazebox Home has a flashing red status LED, the charger is in an error state and requires intervention. In this state, an error
code is displayed on the screen. Please refer to the following table for a description of the problem.
Code
01
1
02
2
03
3
04
4
05
5
06
6
07
7
08
8
These errors are automatically resolved as soon as the vehicle charging cable is disconnected. If these errors persist, it is
necessary to contact Daze technical support.
18.
D
xxxx xxxx
Type of error
Critical internal
temperature
Residual current
detected
Residual current
test failed
Signal detection
Control Pilot failed
Safety switch
blocked
Overcurrent
detection
Signal detection
Invalid Control Pilot
Cable inserted incorrectly
on charger side
To authorize charging via an RFID card on a locked
charger, approach the card to the designated
symbol on the Dazebox Home display (fig. D) until
kW
a short beep is emitted. Following the signal, the
charger will check the card's authorizations via
the internet. A second signal after a few seconds
will indicate whether the authorization was suc-
cessful (single beep) or failed (double beep).
Detected a significant increase in
No voltage detected on the signal
Control Pilot of the cable between
Safety switch locked: Dazebox Home starts the reco-
very procedure. Be careful not to touch the electrical
Stopped charging: vehicle absorbs
Voltage detection not valid on Control Pilot
signal of the cable between Dazebox Home
Interlock socket detects an error. Disconnect
Description
internal temperature
Possible faults in the electrical
systemof the vehicle
Possible failure of the sensor
dispersion detection
Dazebox C and the vehicle
contacts of the connector
more current than allowed
and vehicl
and reconnect the cable