Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Replace the old lock with the new one
To replace the old lock with this product on the same door, please confirm the backset for the
latch and the specifications for the face plate match. Please also refer to the following
instructions to adjust the backset and face plate to match the existing door's specifications.
For adjustments please refer to the following illustrations.
a. The illustration shows a backset of 2-3/8" (60mm).
b. Pull the cam all the way to the right, to adjust backset to 2-3/4" (70mm).
c. To restore back to 2-3/8" (60mm), push the adjustable sleeve all the way to the left.
a
Note : The correct direction for the cam is
shown as the circle on the left side.
Latch face plate
Prior to installation, please make sure that the face plate is
appropriate for the latch.
Replace the face plate
1. Use the slotted screwdriver to pry open the face plate
and the lock body.
2. Install the appropriate face plate onto the latch body.
Installation of the round face plate
Align the round face plate to the head of the latch, and lock it
into position.
The distance between the edge of the door to the center of the hole is
the latch backset. The adjustable latch provides two choices of backsets
2-3/8" (60mm) and 2-3/4" (70mm). Change the backset for the latch
according to the illustration.
b
c
2
1
1
Publicidad
