Craftsman 137.221960 Manual De Instrucciones página 2

SECTION PAGE
Warranty ................................................................ 2
Product Specifications ..................................................... 2
Safety instructions ........................................................ 3
Accessories and Attachments ............................................... 6
Tools needed for assembly ................................................. 6
Carton Contents .......................................................... 6
Know Your Table Saw ...................................................... 8
Assembly and Adjustments ................................................. 9
Operation .............................................................. 16
Maintenance ............................................................ 20
Troubleshooting guide .................................................... 21
Parts .................................................................. 22
Making a push stick ...................................................... 26
EspaSol ................................................................ 29
FULL ONE YEAR WARRANTY
If this product fails due to a defect in materia) or workmanship within one year from the date of purchase, Sears
will repair it free of charge.
Contact a Sears Service Center for repair
If this product is used for commercial or rental purposes, this warranty applies only for 90 days from the date of
purchase.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
MOTOR
Maximum developed HP ....... 2,5
Volts ....................... 120
Amperes ................. 13
Hertz ......................... 60
RPM (no toad) .............. 5000
Overload protection ........... YES
SAW
Table ............. 17 t/8" x 26"
Blade .................. t0"
Maximum depth of cut at 90 ° ...... 3 inches
Maximum depth of cut at 45 o ..... 2-1/2 inches
Maximum width of dado ........ 1/2 inch
Weight ................. 55 lbs
To avoid electrical hazards, fire hazards, or damage to
the tool, use proper circuit protection.
Your table saw is wired at the factory for 120V operation
Connect to a I20V, 15 AMP branch circuit and use a 15
AMP time delay fuse or circuit breaker, To avoid shock or
fire, replace power cord immediately if it is worn, cut or
damaged in any way..