Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
-
High efficiency and reliability Class D amplifier with built-in Bluetooth®/USB player and FM radio.
-
4 input channels, 3 auxiliary inputs and 4 zone outputs with independent volume controls.
-
Inputs with adjustable VOX priority control.
CONTROLS AND FUNCTIONS
FRONT PANEL
1
PA AMPLIFIER MAX-240Z
1.-
: indicator light and on/off switch of the amplifier.
2.- CH 1|PAGING MIC/CH 2/CH 3/CH 4/AUX|PLAYER: volume controls for inputs CH 1, CH 2, CH 3, and
CH 4 respectively and AUX|PLAYER for AUX 1-3 and player.
3.- AUX 1/AUX 2/AUX 3/PLAY: indicator lights and buttons to activate AUX input 1, AUX 2, AUX 3 or the
built-in player (Bluetooth, FM radio, USB).
1
2
4.- FM/USB: active mode LED indicators on the player.
5.-
: Bluetooth receiver operation indicator light. If there is no paired device it will flash and it will remain
REM. WALL PANEL
CH 1
CH 2
fixed when a paired device is present and ready to send audio.
6.- VOL: master amplifier volume control and amplifier on/off LED indicator.
EMERGENCY IN
7.- PROTECT: protection LED indicator. Lights up when the temperature amplifier protection is activated.
CHIME
VOX 1
VOX 2
VOX 3
CH 1
PHANTOM
CHIME
PHANTOM
With protection enabled, the audio output of that channel is cut off. If this happens, turn off the device,
48 V
CH 1
48 V
VOX 2
LINE
LINE
MIC
MIC
make sure that the vents for air intake and exhaust are free of obstructions and turn down the input
volume. Wait a few minutes for the appliance to stabilize before you switch it on again.
CHIME
REMOTE MUTE
8.- PRIORITY: light indicator for the existence of a signal with VOX priority.
22
21
18
9.- CLIP: signal peak LED indicator. If it lights up lightly or occasionally you should reduce the output
volume. If the indicator light stays on continuously, it is because the input signal is very high. In this
case, reduce the volume of the input signal that's causing it.
10.- SIGNAL: signal LED indicator. Lights up when signal is detected at the outputs.
11.- USB port for audio file playback.
12.-
/ : a short press, in Bluetooth or USB mode skips to the previous/next audio track; in FM mode it
skips to the previous/next stored frequency. In all modes, a long press decreases/increases the volume
of the player.
a bc d
13.-
: in Bluetooth mode, a short press starts/stops audio playback and a long press unpairs the
connected device and awaits pairing again. In USB mode, a short press starts/stops audio playback
and a long press switches the play mode between: repeat all (1 tone) and shuffle (2 tones). In FM mode,
it auto-stores all detected frequencies with sufficient signal quality.
14.- MODE: Short presses of this button allow you to change the mode on the player to choose the desired
audio source: Bluetooth, USB or FM radio.
15.- Z 1/Z 2/Z 3/Z 4: light indicators and buttons to activate/deactivate the ZONE 1, ZONE 2, ZONE 3 and
ZONE 4 output zones respectively.
16.- Z 1/Z 2/Z 3/Z 4: rear panel ZONE 1, ZONE 2, ZONE 3 and ZONE 4 output zone volume controls.
CH 1 | PAGING MIC
CH 2
Z 1
Z 2
16
3
CH 3
CH 4
CHIME
CH 2-4
CHIME
PHANTOM
CHIME
PHANTOM
CHIME
CH 2-4
48 V
CH 2-4
48 V
CH 2-4
VOX 3
VOX 3
VOX 3
LINE
LINE
MIC
MIC
CHIME
CHIME
CHIME
20
19 18
a
b
2
3
CH 3
CH 4
AUX | PLAYER
Z 3
Z 4
MODE
15
4
5 6
7 8
AUX 1
AUX 2
AUX 3
REC OUT
PRE AMP
VOICE PRIORITY (VOX)
1
EMERGENCY IN | REM. MUTE
2
ZONE MICROPHONE
3
REMOTE WALL PANEL
ATTENUATOR PRIORITY
3 WIRE
24 V
100 V
R
R
R
R
PRE OUT
ZONE OUTPUT
ALL ZONES: 240 W RMS (MAX)
EACH ZONE: 240 W RMS (MAX)
ZONE 4 ZONE 3 ZONE 2 ZONE 1
L
L
L
L
AMP IN
17
- 2 -
4
5
6
AUX 1
VOL
AUX 2
AUX 3
PLAY
FM
USB
14
12
13 12
9
10
11
12
FM ANTENNA
BLUETOOTH® ANT.
4
CH 1 | PAGING MIC
5
CH2 | CH3 | CH 4
6
AUX | PLAYER
TONE CONTROL
MAX-240Z
PA MIXING AMPLIFIER
BASS
TREBLE
ZONE MICROPHONE
SPEAKER OUTPUT
RS-485 + AUDIO
240 W RMS
~115 V AC, 50/60 Hz, FUSE: T8 A 250 V
~230 V AC, 50/60 Hz, FUSE: T4 A 250 V
POWER CONSUMPTION: 345 W
16
15
7
PROTECT
8
PRIORITY
9
CLIP
SIGNAL
10
11
13
AC SELECT
14
Publicidad
