Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION
IMPORTANT: cool the power amplifier properly. To do this, make sure that the place where it is installed has
access to airflow and that the slots in the chassis are free of obstructions.
-
With the amplifier turned off, connect all CH, AUX and EMERGENCY IN audio sources and select the
LINE/MIC input type and enable/disable PHANTOM power on channels CH 1 to CH 4 using the DIP
switches on each input channel.
(OPTIONAL) Connect the zone microphone and wall panel.
If you are going to use the FM radio, you will need to connect an FM receiver antenna.
-
Connect the loudspeakers to the corresponding low impedance output* (4 Ω + COM), 100 V line*
(100 V + COM), 70 V line* (70 V + COM), zones* (ZONE 1-4) or to the stereo recording output (REC OUT).
*IMPORTANT: for proper operation and performance of the device, use the correct power, impedance
and frequency limits. Before connecting to other equipment, be aware of the conditions required in a
HIGH IMPEDANCE (100 V) and LOW IMPEDANCE installation.. More information can be found at:
-
Check that the volume and gain controls are at minimum and connect the amplifier to power.
-
Turn on the amplifier and activate the AUX or PLAY input and outputs (if using the ZONES output) you
wish to use using the buttons on the front panel of the amplifier.
-
Check the volume controls for inputs, outputs, and master volume.
-
PRIORITY: enable priority on the desired inputs using the DIP microswitches and regulate sensitivity
using the VOX controls on the inputs.
-
Finally, adjust the equalisation using the BASS and TREBLE controls on the rear panel.
fonestar.com/downloads/install_fonestar_es.pdf
- 7 -
EN
Publicidad
