Jatrhg LZ-32-P Manual Del Usuario página 3

1. Safety Instructions
Before starting the installation and use of the JATRHG charging station,
users must carefully read this document, heed all warnings, and follow
all the instructions provided herein.
Failure to do so may result in electric shock, which could be fatal or cause serious
injuries. The information contained in this document is subject to change without
notice and does not constitute any commitment on the part of TAMITO SAS. TAMITO
SAS is not liable to any person or entity for any injury, damage, or direct or indirect loss
resulting from improper installation or use of the device.
ELECTRICAL WARNINGS
The JATRHG charging station must always be installed by

qualified personnel in accordance with the electrical regulations
applicable in your country.
The JATRHG charging station is an electrical device that is always connected to an

AC voltage of 230 V, hence touching any non-insulated parts (for example, PCB pins
inside, connectors, non-insulated parts of wires) will result in an electric shock.
DO NOT OPEN the front cover while the JATRHG charging station is operational; there
is a risk of electric shock.
DO NOT touch the connector pins.
DO NOT insert tools inside the type 2 vehicle connector.
If it is necessary to open the front cover (for example, during installation), always

disconnect the power supply from the central circuit breaker.
The JATRHG charging station is for adult use only.

The use of adapters, conversion adapters, and extension kits

is not permitted!
Disconnect the power if the red LED lights up!

DO NOT touch pins, electronic components, and the terminals of the printed circuit
board (PCB) to avoid electrostatic discharges (ESD) that could damage the product.
Never install a damaged product.
Otherwise, electric shocks and/or property damage could occur (including to the
electric vehicle).
EN
2. Installation:
Before beginning the installation and use of the JATRHG charging station, the user
must always read this document carefully, take into account all the warnings, and follow
all the instructions outlined in this manual.
REQUIRED TOOLS
To properly install the JATRHG charging station, the following tools are required:
INSTALLATION PLANNING:
Before beginning the installation, the following recommendations should be
considered:
 Ensure that the charging station can be vertically installed on a solid, fire-resistant
wall or on the optional metal pole;
 Ensure there is enough space for the installation of the charging station.
 Ensure that the required power cable (not included) from the junction box to the
charging station can be installed in accordance with the electrical regulations
applicable in your country;
 Ensure that the electric vehicle can be parked near the charging station for
extended periods, so that the charging connector with an 8 m cable can be
plugged into the electric vehicle's charging socket;
If an optional metal pole is used, ensure it is mounted at the highest point off the
ground so that the base of the metal pole does not sit in a puddle of water during rain.
Cable Requirement
The minimum cable required for this charging device is 3*6mm square. The
[ LZ-32-P 7kw]
length shall not exceed 40 meters. If more than 40 meters, please choose 3*10 mm square
cable. Use at least C40 circuit breaker for a 7KW charger.
EN