Publicidad
Idiomas disponibles
Idiomas disponibles
,
MANUAL TUNING
1>
I
f
1 Press the TUNER button repeatedly to select the
desired band.
~
The display changes
to frequency
indications
after indicating
band and video source (V1, V2 or V3) for two seconds.
When the TUNER
button is pressed
while the power is off,
the power is turned on directly.
2 Press the
UPA
or DOWNY
button to select a
station.
Each time the button is pressed,
the frequency
changes.
[
When
a station
is received,
"TUNE"
is displayed
for two
seconds.
During FM stereo reception,
[{(m)]) is displayed.
,
To search for a station quickly (Auto Search)
Keep the UPA or DOWNT
button pressed
until the tuner starts
searching
for a station.
After tuning
in to a station,
the search
stops.
To stop the Auto Search manually,
press the UPA
or DOWNY
button,
The Auto Search
mqy not stop at stations
with '"very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER
button on the remote control
so that
"MONO
appears
on the display.
Noise is reduced,
although
reception
is monaural.
To restore
stereo
reception,
press the button so that "MONO?'
disappears.
DIRECT TUNING
f?====%
I
DOWNY,
UPA
When you know the frequency
of the desired
station,
you can
tune in directly to the station.
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
"
"flashes on the display (DirectTuning
Mode).
.....
3 Press the appropriate numbered buttons,to tune
in to the desired station.
Example:
To tune in to 106.50 MHz, press 1, 0, 6, 5 and O buttons.
To tune in to 95.20 MHz, press 9, 5, 2 and Q buttons.
To
cancel the Direct tuning mode
Press the UPA or DOWNY
button.
When using the remote control
Carry out steps 1 and 2 above, and press the numbered
buttons
on the remote control to tune in to the desired
station.
When
entering
a frequency
out of tuning
range,
the value
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
When entering" a frequenc~
not covered
by the tuning interval,
the value is automatically
rounded
up or down to the closest
one covered
by it.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If
you use this unit in an area where the frequency
allocation
system
is 9 kHz/step,
change the tuning interval.
Hold down the TUNER
button and press the POWER
button
immediately.
Note that the unit is set to the Direct Tuning mode
if the TUNER
button is pressed
and held down for about half
a second.
To reset the interval,
repeat this procedure.
Publicidad
