Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE CLOCK
SETTING THE SLEEP TIMER
1,3,5
1,,----,!.
When the AC cord is connected
for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1 Press the SET button.
The hour flashes.
2 Press the DOWNY
or UPA button to designate
the hour.
3 Press the SET button to set the hour.
The hour stops flashing
and the minute starts flashing.
4 Press the DOWNY
or UPA button to designate
the minute.
5 Press the SET button to set the minute.
The minute stops flashing
on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER
button
to turn the unit off. Press the SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK
button
on the remote
control.
The clock
is
displayed
for 4 seconds.
,
To switch to the 24-hour standard
Press the POWER
button while pressing
the UPA
or DOWNY
button while the current time is displayed.
Repeat the same procedure
to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
24 hours, all
settings
stored in memory
after purchase
need to be reset.
I 5
ENGLISH
The receiver can be automatically
turned off at a specified
time.
Use the remote control.
1 Press the SLEEP button.
2 Press
the
UP>
or
DOWN<
button
within
four
seconds
to
specify
the
time
until
the power is turned off.
Each time the button is pressed,
the time changes
between 5
and 240 minutes
in 5-minute
steps.
Specified time
To
check the time remaining until the power is turned off
Press the SLEEP button once. The remaining
time is displayed
for four seconds.
To cancel the sleep timer
"
Press the SLEEP
button twice so that "SLEEP"
on the display
disappears.
Publicidad
