Softing CableMaster 210 Guia De Inicio Rapido página 2

Operation
Operation
Operation
Operation
Operation
Operation
Operation
© 2023 Softing IT Networks GmbH
CableMaster 210
Quick Reference Guide
v1.1223
itnetworks.softing.com
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage rapide - Guía rápida - Guida rapida -
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage rap
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage
CableMaster 210 Quick Start Guide
CableMaster 210 Quick Reference Guide - Kurzanleitung - Guide de démarrage
1
1
1
1
1
1 RJ45 test port
2 Backlit screen
3 Test button
4 On/Off button
5 Internal remote - removable
The internal remote can be used both in the
device and externally.
To remove the remote from the device, pull the
remote down and out of the main device.
The internal remote bears the identifier #1.
6 Tone generator - button
7 Battery cover
Switching on
Press and hold any key briefly.
If you briefly press and hold the key (3), the wiring
mode is activated immediately.
If you briefly press and hold the key (6), the tone
generator is activated immediately.
Switching off
The device switches off automatically.
If you keep the key (4) pressed for a long time, the
device switches off.
Single test
Press and hold the key (3) briefly to start a wiring
test.
Continuous test
If you keep the key (3) pressed for a long time, the
continuous test mode is activated. In this mode,
wiring tests are performed continuously until the
mode is terminated.
Activate backlight
Press and hold the key (4) briefly when the
instrument is switched on.
Tone generator
Press and hold the key (6) briefly to activate the
tone generator. Pressing the key (6) several times
will cycle through the operating modes of the
tone generator.
The tone emitted by the unit can be received with
compatible receivers such as CP15.
It is possible to select different tone sequences
and wire or pair combinations.
To change the batteries, open the battery
compartment (7) and replace the two AAA
batteries. Use only 1.5V alkaline batteries.
EN
2