Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE
GENERATOR
FROM
CARTON
Open top flaps of shipping carton.
Slice two corners at end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
Remove the generator and contents from the
shipping carton.
CARTON
CONTENTS
Check all contents against those listed below:
Main unit
Engine oil
Owner's manual
Wheel Kit
If any parts are missing or damaged, call the
generator hetpline at 1-800-222-3136.
INSTALL
WHEEL
KIT
NOTE: While the wheel kit is designed to greatly
improve the portability of your generator, it is not
intended for over-the-road use.
You will need a socket wrench with 1/2" or 13mm
sockets, a 5/16" wrench and a needle-nose pliers to
install this kit.
Install the Wheel Kit as Follows:
1.
Place bottom of generator cradle on a flat surface.
2.
Place axle stud through wheel retainer on cradle
frame, as shown below.
3.
Use 15/16" wrench to secure axle stud to frame
with 5/8-18 jam nut.
4.
Install other axle stud in same manner.
NOTE: Be sure to install wheel with raised hub inboard.
5.
Tip unit and install wheel. Place flat washer over
axle stud.
6.
Retain wheel on axle stud with retaining pin.
Install other wheel on remaining axle stud the
same way.
7.
Attach support leg using two 13mm wrenches with
20mm cap screws and lock nuts.
8.
Center lifting handle on generator end of cradle.
Attach handle using two 13mm wrenches with
capscrews and hex nuts.
Capscrew
Jam Nut
Washer
Mountin
Axle
Stud
\
/
/
Capscrew
/
Wheel
Retaining Pin
6
Publicidad
