Publicidad
A
WA R NI, N G
Electrical Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Cleaner will
1. Unplugged at wall outlet.
1. Plug in firmly. Push ON-OFF
not run.
switch to ON,
. Push ON-OFF switch to ON.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
. Reset circuit breaker or replace
fuse.
Poor job of dirt
1. Full or clogged dust bag.
pickup.
2. Broken belt.
. Change bag.
. Replace belt.
3. Carpet-bare fioor setting incorrect.
. Set in the correct position.
4. Clogged hose or nozzle.
. Clean hose or nozzle area.
5. Hose not inserted fully.
. Insert hose.
6. Worn agitator.
. Replace agitator.
7. Hole in hose.
. Replace hose.
8. Dust cover improperly installed.
. Properly install dust cover.
20
fF
NON
bh
GQ
HN
. Install belt on motor shaft.
Bare floor option | 1. Belt improperly installed with bare | 4. Properly install belt.
will not work.
floor setector in wrong position.
Dust escapes
1. Bag improperty installed.
1. Properly install bag.
9. Belt not installed on motor shaft.
the paper bag.
2. Bag torn.
2. Replace bag.
Light will
1. Burned out light bulb.
e
1. Replace light bulb.
not work.
- 20-
Publicidad
