cecotec BOLERO COOLMARKET COMBI 262 WHITE E Manual De Instrucciones página 28

ENGLISH
7. Switch-on
Connect the plug into a power socket to switch on the compressor. After one hour, open the
refrigerator door: if the temperature inside the refrigerator compartment has dropped, this
means the cooling system is running normally.
8. Food storage
After the refrigerator has been in operation for some time, the user may adjust its internal
temperature. Once the refrigerator has reached a suitable interior temperature, put in the food.
If the refrigerator is installed in a wet place, be sure to check if the earth wire and the circuit
breaker are working normally. If vibration noises occur due to contact of the refrigerator
with the wall or if the wall turns black due to air convection around the compressor, keep
the refrigerator further away from the wall. The installation of the refrigerator may cause
noise interference or image problems in mobile phones, landline phones, radio receivers, or
televisions near the refrigerator, so in this case, keep the refrigerator as far away from these
objects as possible.
Reversing the door opening direction
1. Make sure the refrigerator is unplugged.
Lift up and remove the hinge cover, remove the three screws securing the top hinge to the
2.
door, then remove the hinge. Fig. 3
3. Remove the refrigerator-compartment door.
4. Remove the two screws securing the centre hinge. Fig. 4
Remove the freezer-compartment door.
5.
6. Remove the screws securing the bottom hinge on the right side of the refrigerator, then
remove the hinge. Fig. 5
7. Remove the washer and the nut that fix the shaft pin to the right gap of the lower hinge
and remove the shaft. Fig. 6.
8. Insert the pin shaft into the left hole of the lower hinge, then secure the shaft with the
washer and nut. Fig. 7
9. Install the lower hinge on the left side of the refrigerator.
10. Remove the screw securing the door stop on the bottom right-hand side of the freezer-
compartment door, then remove the door stop and install it on the bottom left-hand side.
Fig. 8
11. Install the freezer-compartment door.
12. Move the door bushing from the top right-hand side of the freezer-compartment door to
the top left-hand side. Move the left-hole cover to the right side. Fig. 9
13. Remove the screw-hole cover from the centre-hinge screw hole on the left side of the
refrigerator, then install it into the screw holes on the right side of the refrigerator. Fig. 10
14. Install the centre hinge on the left side with the two screws removed earlier. Fig. 11
15. Remove the screw that holds the door stop on the lower right side of the refrigerator-
B O LE R O COOLM ARKET COM BI 2 62 W HIT E E
54
compartment door and remove the door stop from the door. Then install it in the lower
left side. Fig. 12
16. Install the refrigerator-compartment door.
17. Move the door sleeve from the right top chamber of the refrigerator to the upper left side
of the door. Move the left-hole cover to the right side. Fig. 13
18. Remove the cover from the hole in the top left-hand side of the refrigerator and attach
the cover to the top right-hand side of the refrigerator. Fig. 14
19. Attach the top hinge to the top-left side of the refrigerator with the three screws removed
earlier. Before tightening the top hinge screws, make sure that the top of the door is level
with the refrigerator and that the rubber gasket makes a good seal.
20. Place the cover on top of the hinge on the top left side of the refrigerator. Fig. 15
Fig. 3 key:
1. Hinge cover
2. Screws
Upper hinge
3.
Fig. 4 key:
1. Refrigerator-compartment door
Centre hinge
2.
3. Screws
Fig. 5 key:
Lower hinge
1.
2. Screws
Fig. 6 key:
Pin shaft
1.
Fig. 7 key:
1. Pin shaft
Fig. 8 key:
1. Freezer-compartment door
2. Door stop
Fig. 9 key:
1. Bushing
2. Hole cover
B OLERO COO LMARKET COMBI 262 W HITE E
ENGLISH
55