English
Error
LEDs on the
battery
The KombiEn‐
3 LEDs light up
gine cuts out
red.
during operation.
The KombiEn‐
gine runtime is
too short.
The power levels
cannot be set.
The STIHL con‐
nected app is
unable to find the
battery with
.
19.2
Product Support and Assis‐
tance on Use
Product support and assistance on use are avail‐
able from STIHL servicing dealers.
For contacts and other information, please visit
https://support.stihl.com or www.stihl.com.
20 Specifications
20.1
KombiEngine STIHL
KMA 135 R
– Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without KombiTool: 3.4 kg
– Degree of protection: IPX4 (protection against
splash water from any direction)
For runtime, see www.stihl.com/battery-life.
20.2
STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
®
– Bluetooth
radio interface (only for batteries
with
):
36
Cause
The KombiEngine is
too hot.
There is an electrical
error.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The trigger is depres‐
sed and the KombiEn‐
gine switched on.
®
The Bluetooth
radio
interface on the bat‐
tery or mobile device
is deactivated.
Excessive distance
between the battery
and the mobile
device.
– Data connection: Bluetooth
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
– Mobile appliance operating system require‐
Remedy
► Remove the battery.
► Allow the KombiEngine to cool down.
► Remove the battery and reinsert it.
► Switch on the KombiEngine.
► Fully charge the battery as described in
the user manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Replace the battery.
► Release the trigger and hold only the
trigger lockout pressed.
► Select the power level as described in
this user manual.
► Activate the Bluetooth
on the battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer.
mobile appliance must be compatible with
®
Bluetooth
Low Energy 5.0 and support
Generic Access Profile (GAP).
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
ments: Android or iOS (current version or
higher)
20 Specifications
®
radio interface
20.2.
®
5.1. The
0458-687-9802-A