Vortice VORT HRI 200 PHANTOM BP IoT Manual De Instrucciones página 40

ENGLISH
e
OBLIGATION
- If the appliance does not function correctly or develops a fault, contact a VORTICE authorised Technical Support
Centre without delay. Ensure that only genuine original VORTICE spares are used for any repairs.
- If the power supply cable is damaged, have it replaced without delay by a VORTICE authorised Technical Support
Centre.
- Should the appliance be dropped or suffer heavy impact, have it checked without delay by a VORTICE authorised
Technical Support Centre.
- The appliance must be installed in such a way as to ensure that under normal operating conditions, no one can
come into contact with any moving parts or live electrical components.
- The appliance internal parts must be cleaned only by a skilled professional.
- Regularly inspect the appliance for visible defects. If the appliance is defective in any way, do not use it, and
contact a VORTICE authorised Technical Support Centre without delay.
i
OBLIGATION
- Follow the safety instructions to prevent any harm to the user.
- Maintenance instructions must be followed to prevent damage and/or excessive wear to the appliance.
d
PROHIBITION
- Do not use this appliance for functions other than those described in this booklet.
- Do not leave packaging within reach of children or individuals with disabilities.
- Do not operate the appliance where inflammable vapours or substances are present (alcohol, insecticides, petrol,
etc.)
- Do not make modifications of any kind to this appliance
- Do not expose the appliance to the weather (rain, sun, etc.).
- Do not stand objects on the appliance.
- The appliance cannot be used to pilot the operation of water heaters, stoves, etc.; neither must it drain into the
hot water ducts of such appliances.
a
ATTENTION
- Certain fundamental rules must be observed when using any electrical appliance:
– never touch the appliance with wet or damp hands.
– never touch the appliance while barefoot.
- The flow of extracted air must be clean (i.e. free of grease, soot, chemical and corrosive agents and explosive or
flammable mixtures).
- Keep the air intake and outlet ports of the appliance free of obstructions, to ensure optimum air flow.
- Maximum operating temperature: 45°C.
p
OBLIGATION
- In the case of:
– dismantle the appliance, using the proper tools.
– heat exchanger removal.
– motor module removal.
the appliance must first be switched off and disconnected from the electrical power supply.
- Switch off the system main switch when:
– a malfunction is detected.
– you decide to perform external cleaning maintenance.
– you decide not to use the device for short or long periods.
5 Structure and equipment
The main components of the appliance are:
• An external body made of galvanised steel.
• The heat exchanger, made of polystyrene, of the counter-current flow type, whose
particular morphology ensures very high heat exchange efficiency; the H models
are equipped with an enthalpy exchanger, which is also able to transfer the humidity
present in the air.
• The two motors are the brushless type with low consumption and variable speed (4
pre-set speeds).
• An electronic controller which oversee the power supply and command and control
of the appliance.
• Two thermal actuators that manage the opening of the bypass valve.
• Remote control panel.
• 4 temperature sensors.
• 2 M5 filters (pos. 1 fig. 2 : extraction filter / pos. 2 fig. 2 supply filter).
40
2
1
B
A
2
C
D