Vortice VORT HRI 200 PHANTOM BP IoT Manual De Instrucciones página 50

ENGLISH
8.2 V ia the "Vorticenet" Cloud
1. Power the appliance. The Wi-Fi LED on the remote control panel flashes. The appliance must be in Bluetooth mode (the
LED on the remote control panel must flash quickly. If the LED is steady, please refer to paragraph 9.1 to switch to
Bluetooth mode).
2. Open the "VORTICE MVHR" app and start the scan.
3. Start the scan and select the "Internet Gateway" button.
4. Select the button "VorticeNET cloud installation process".
5. Select the "Start" button.
Device choice
Start scan
6. At this point, use a separate browser (e.g. via a laptop or other device connected to WiFi) or start the "VORTICENET"
app, following the tutorial screens that appear on the "VORTICE MVHR" app.
7. Go to www.vorticenet.it via browser or open the "VorticeNET" app.
8. Proceed with registration or enter your credentials if you are already registered.
9. Press the "+ Add" button. ***
10. Enter the NAME and serial number ('SERIAL NUMBER') that appears when scrolling through the tutorial screens on the
"VORTICE MVHR" app. Press the "Next" button and accept the terms of use.
11. Enter the password that appears while scrolling through the tutorial screens on the "VORTICE MVHR" app. On the
browser or on the "VorticeNET" app, the message "Configuration was successful. To use the installation, please switch
the gateway to WiFi mode." will appear Press the "Next >" button on the "VORTICE MVHR" app.
12. Configure the network on the "VORTICE MVHR" app by entering the SSID (network name) and the password of the WiFi
network you are connecting to.
13. Activate the Wi-Fi mode via the button that appears on the "VORTICE MVHR" app screen and press the "Complete"
button.
14. The connection procedure to "Vorticenet" is now complete. A warning appears on the "VORTICE MVHR" app that the
connection (BT) to the device is now interrupted. Once the "Ok" button is pressed, the appliance will be controllable via
Wi-Fi from the "Vorticenet" cloud.
***If you are using the "VorticeNET" app, you can choose between Bluetooth (BT) or manual installation.
Manual
- Manual
After starting the app and clicking on the "+ Add" button, select the "Manual" button on the app and follow the procedure
described in steps 10 to 14.
Note: Only the manual procedure just described can be carried out from the browser.
BT
- BT (Bluetooth)
Important note: With this option, it is not necessary to install the "VORTICE MVHR" app to carry out system
installation. You are not required to enter a password with this pairing procedure.
• After selecting the "BT" button, it is necessary to switch to Bluetooth mode manually from the remote panel (see
paragraph 9.1 - flashing
• The system will search for devices to connect. Select the device found, press the "Next" button and accept the
terms of use.
50
Device choice
device name:
Internet gateway
FN:
1006859209
MAC:
B8:D6:1A:A5:A8:DE
LED).
Selected device
Internet gateway
Device:
1006859209
FN:
VorticeNET Cloud installation process
Internet gateway settings
device name:
Ventilation controlle
r
FN:
1006930839
producer:
Vortice