Vortice VORT HRI 200 PHANTOM BP IoT Manual De Instrucciones página 67

• During the NO FROST procedure, the BYPASS damper is closed.
10.6 Boost mode settings
The installer must leave the "Normally Open" setting at "Logic status IN1".
Boost mode settings
Boost mode IN1 Logic state
Supply fan control from IN1
Extraction fan control from IN1
10.7 Modbus settings
Modbus settings
Modbus address
Transmission speed
Number of stop bits
Modbus activation
Edit parameters
Ventilation unit control
10.8 Manual control
This function is reserved for professionally qualified personnel only.
With the appliance switched off, if you set manual control to "Yes", you can access a sub-menu to check that the appliance
is working properly.
The available options are as follows:
• OUT1 = switches the heater on off when connected.
• OUT2 = controls bypass opening
• OUT3 = controls bypass closing
• AOUT1= controls supply motor speed (0 to 100%)
• AOUT2= controls extraction motor speed (0 to 100%)
Note 1: The same operation can also be carried out via the "VORTICE MVHR" app, under the "Service Settings" menu.
When the appliance is switched off, "Manual control" appears. Select "Yes" to activate the manual control function.
Note 2: To return to controlling the appliance via the "VORTICE MVHR" app, remote panel or cloud, you must disable the
"Manual control" function by setting the item to "No".
10.9 Installer setting
By accessing the drop-down menu
the ventilation system from the cloud using the dedicated button.
From this page it is also possible to enter contact data and change the name of the installation.
, from the button " Installer setting ", it is possible to remove the installation of
ENGLISH
Normally Op...
100%
-100% 100%
100%
-100% 100%
1
1
115200
1 stop bit
Yes
Yes
Yes
247
67