GE GFDS575 Manual Del Propietario E Instalación página 12

Installati
Instructi
n
ns
Dryers
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
_4_ This is the safety alert symbol. This symbol alerts you to potential hazards that can killyou or hurt you and others.
All safety messageswill follow the safety alert symbol and the word "DANGER", "WARNING", o r "CAUTION". These
words are defined as:
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoidec could result in death or serious injury.
_ Indicates a hazardous situation which, if not avoidec could result in minor or moderate inJury.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT-
Save these instructions for local
electrical inspector's use.
•
IMPORTANT-
Observe all governing codes and
ordinances.
• Install the clothes dryer according to the manufacturer's
instructions and local codes.
• Note to Installer - Be sure to leave these instructions
with the Consumer.
• Note to Consumer - Keep these instructions for future
reference.
• Clothes dryer installation must be performed by a
qualified installer.
• This dryer must be exhausted to the outdoors.
, Before the old dryer is removed from service or
discarded, remove the dryer door.
, Service information and the wiring diagram are located
in the control console.
, Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
, Proper installation is the responsibility of the installer.
, Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above 50°F
for satisfactory operation of the dryer control system.
, Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
- Fire Hazard
• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these
instructions and local codes.
DO NOT install a clothes dryer with flexible plastic
venting materials. If flexible metal (semi-rigid or
foil-type) duct is installed, it must be UL-listed and
installed in accordance with the instructions found
in "Connecting the Dryer to House Vent" later in
this manual. Flexible vent materials are known to
collapse, be easily crushed and trap lint. These
conditions will obstruct dryer airflow and increase
the risk of fire.
DO NOT install or store this appliance in any
location where it could be exposed to water or
weather.
To reduce the risk of severe injury or death, follow
all installation instructions.
Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
12