GE GFDS575 Manual Del Propietario E Instalación página 28

Installation Instructions
EXHAUSTING THE DRYER {cont.)
SIDE VENTING (cont.)
ADDING ELBOW AND DUCT FOR EXHAUST TO
LEFT OR RIGHT SIDE OF CABINET (cont.)
, Apply duct tape as
shown on thejoint
between the dryer
internal duct and the
elbow, and also the joint
between the elbow and
the side duct.
Use 4" rigid metal ducting
only inside the dryer. Internal duct joints must be
secured with tape, otherwise they may separate
and cause a safety hazard.
ADDING COVER PLATE TO REAR OF CABINET
(SIDE EXHAUST)
(Kit WE!IVb54)
Connect standard metal elbows and ducts to
complete the exhaust system. Cover back opening
with a plate (Kit WE1P1454) available from your
local service provider. Place dryer in final location.
NEVER LEAVE THE BACK OPENING WITHOUT THE
PLATE. (Kit WEIM454.)
BOTTOM VENTING:
Dryer Exhaust to the bottom of cabinet for
Gas and Electric models.
- Fire Hazard
Close the back opening with cover plate (Kit
WEllV1454).
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Failure to do so may result in fire, electrical shock
or lacerations.
Remove
screw
and save
Bottom Rem_ov e desired
knockout (one only)
Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Detach
and remove the bottom knockout.
Fixing hole
, A
.....................
15 _Z _
Cut the duct as shown and keep portion A.
28