Publicidad
Idiomas disponibles
Idiomas disponibles
Fanaway Brisbane Installation Instructions
INSTALLATION OF THE CANOPY (Fig.17)
Slide and align the canopy up to the mounting bracket. Ensure all electrical wiring is tucked inside the
canopy and that the wires are not damaged during this step. Secure the canopy to the hanger bracket
using the screws provided.
Pairing Transmitter and Receiver – when 2 or more ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for
each fan set to a different code, so that the operation of one fan does not affect the operation of the
other fan/s. The DIP switches for the transmitter (remote hand piece) are located in the battery
compartment of the transmitter. Configuring the DIP switches will allow a unique transmission code
assigned to each fan ceiling.
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.
Transmitter / Receiver pairing for Ceiling fan 1:
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
⚫
Install the 12V battery in the compartment. Please make sure the polarity of the battery is
⚫
correct.
Change the position of the DIP switches in the transmitter 1,
so that it will be different to transmitter 2.
Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must
⚫
have its own isolation switch, so that only the ceiling fan that needs to be paired with the
transmitter will be ON).
Press and hold the Any button of transmitter 1 in excess of 3 seconds within 60 seconds of
⚫
switching the power ON to the receiver of ceiling fan 1.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is
activated.
FINISHING THE INSTALLATION
Fig. 17
USING YOUR CEILING FAN
(Fig. 19)
(Fig. 18)
10 | P a g e
Publicidad
