Troy-Bilt 020210 Manual Del Propietário página 8

Section 3: Assemb(y
2,
Similarly, attach other end of high pressure hose to
high pressure oudet on pump (Figure 5). PuHH down on
coHHar o f quick connect_ sHideonto pump and Hetgo of
coHHar, PuHH on hose to be sure of tight connection.
Connect high
pressure hose here
3,
Before connecting garden hose to water inHet_ inspect
inHetscreen (Figure 6).
CHeanscreen if it contains debris, repHace if damaged.
DO NOT RUN PRESSURE WASHER IF SCREEN IS
DAHAGED,
;_/_7 _ DO NOT use if
_amaged, dean if
dirty.
4. Run water through garden hose for 30 seconds to
dean out any debris.Turn off water.
[MPORTANT: DO NOT siphon standing water for the
water supply, Use ONLY coHd water (less than [00°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inHet.Tighten by hand (Figure 6).
Damageto equipment resulting from failure to follow this
instruction will void warranty,
6, Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities,
WANNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection,
Checklist Be[ore Start[n Eg Eng[ne
Review the unit's assembHy to confirm you have performed
aHH of the following:
H. Hake sure handHe is in pHace and secure.
2. Check that oi[ has been added to proper [eve[ in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properHy attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water suppHy (not to exceed H00°F)
at an adequate flow.
7. Be sure to read "Safety RuHes"and "HowTo Use
PressureVVasher" before using pressure washer.
O