Suntec Wellness KLIMATRONIC EFFECT 7.0 Eco R290 Manual De Operación página 17

•
Press the SWING button to activate the automatic oscillation function. Press the button again to lock
the slats in their current position. To unlock the slats and reactivate the automatic swing function, press
the button again.
•
Note: Please never move the slats by hand to avoid damage to the mechanism.
Compressor protection
•
The compressor requires a start-up phase and will start with a three minutes later after turning on / off
to reboot the device.
Frost protection
•
In cooling and dehumidifying the unit has an automatic frost protection function designed to protect the
unit at low temperatures. The device also has an automatic defrosting function.
Emptying of the water tank
•
As soon as the water tank is full, the "Watertank full" Indikator
illuminates on the display.
•
Turn off the power and unplug the power cord. To empty of the
water tank you need to remove the rubber stopper on the bottom
of the unit and let the water leak into a container. Once you reboot
the device, it will work normally (Pic. 7).
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and neutral
detergent and then wipe dry with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks. Clean the dust filter with
neutral detergent and about 40°C water. Rinse off any detergent, then
let it air-dry before inserting it back into the unit (pic.8).
•
If you do not use the unit for a longer time, empty the water tank
completely. Make sure that the unit is disconnected from the power
supply and that it is clean. Keep the unit covered in a dry place.
Troubleshooting
Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
Possible causes
The water tank is full and the water full
indication light lights up.
Air inlet is blocked.
Room temperature is lower than the set
temperature during operation mode
cooling.
The ambient temperature is too low or
too high.
In dehumidification mode, the ambient
temperature is too low.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Pic.7
Pic.8
Suggestions
Empty the water tank.
Clean the air inlet
Reset the temperature.
We recommend the operaiton at 17-35°C.
The ambient temperature needs to be
higher than 17°C.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.