Publicidad
Idiomas disponibles
Idiomas disponibles
23 / EN
•
This water heater should be installed inside or in enclosed spaces, because it does not
require ventilation.
•
The heater must be located away from flammable materials or places with strong
magnetic fields.
•
If it is installed outside, the heater requires protection against the rain, preferably a
roof at a minimum of 80 cm from the heater cover. If the heater is not protected from
the rain, this could damage the equipment and the electrical installation, rendering the
warranty void.
•
The heater must be perfectly fixed to avoid movement during earthquakes and/or
tremors, in order to prevent it falling from its position. It must also be protected by a
roof or niche to avoid direct contact with the rain.
•
Remove the 2 screws that fasten the front cover on the water heater
(see Fig. 3) and remove the front cover.
•
The surface where the heater will be installed must be solid and secure. DO NOT install
the unit over connections or electrical boxes.
•
Place the heater on the surface where it will be installed. Check that it is leveled.
•
Install the heater on the wall with the 4 screws and 4 wall plugs provided at the marked
points (see Fig. 4). The non-use of these may cause damage to the installation.
FIG. 2
Do not install the heater in
reverse or lateral position
Publicidad
